Guide to mounting and using a mast with external cord system

Put cord holder with the two riveted holes in the mast
and fasten it to the mast with two bolts.
Put cord through the sleeve both cord output zones ja
pull the cord straight to the lower end of the mast. Cut
shorten the cord so that both ends of the cord remain
30 cm below the cord holder. Burn the ends of the string so that
to prevent the cord from branching.
Tie one end of the string plastic carabiner.
Push sleeve the tip of the mast so that it locks in place.
Bring the other end of the cord to the cord holder and pass it through the holder cord hole so both ends of the cord would remain on the same side of the cord holder.
Attach to this end of the cord as well plastic carabiner.
Connect the carbines.
Pull both cords straight together and wind them together around the cord holder.
Turn around top ball to the sleeve.
Push flagging stand up and adjust the adjusting nuts; tighten the nuts.
Release the double cord from the cord holder and bring down the plastic carabiners, pulling on the cord from the carbines.
Disconnect the plastic carabiners from each other.
Attach the upper carbine to the upper eyelet of the flag and the lower carbine to the lower eyelet of the flag.
Raise the flag by pulling on the string until the flag reaches the top of the mast.
The strings together and moderately taut holding the kinintage ones to the string holder.
Check and, if necessary, tighten the anchor nuts 2 - 3 weeks after installing the mast